Feature #1963

Add support for hardware CAM

Added by Todor Todorov over 3 years ago. Updated 11 months ago.

Status:FixedStart date:2014-02-09
Priority:NormalDue date:
Assignee:-% Done:

100%

Category:Descrambling
Target version:-

Description

Currently TVheadend supports only softcams like OScam.
However, there are certain cards (like the modern NDS cards) which are paired either with the operator's STB or a CAM module provided by the operator.
Such cards can not be read by any of the softcams available at the moment.
The service providers are offering a CAM module with card in order to receive their services in 3rd party STBs.
You can refer to DVBlast and MumuDVB for their implementation of support for hardware CAMs.

History

#1 Updated by Mariusz Białończyk about 2 years ago

  • Status changed from New to Fixed
  • % Done changed from 0 to 100

#2 Updated by over drive 11 months ago

How can it be set in TVH, and which kind of hardware CI is now supported?

#3 Updated by Bengt Madeberg 11 months ago

It is supported but it's not working very well. It's maybe not due to tvh. In my case it can be the HW CAM itself, the interface to the tv-card or the SW driver. The channel switching takes long time and in 50 % of the cases the channel does not show up at all. The CAM also get "lost" for some reason. This happens very often. Then I must enable it again. I plan to buy a "approved" STB from my provider and use a HDMI encoder instead. I will loose some quality but it's better than nothing. Hopefully the channel switching can be done by LIRC ?

#4 Updated by over drive 11 months ago

Thanks for the feedback,
can you response to the thread in created?
Because i dont know i understand the hw cam support in the right way.

https://tvheadend.org/boards/13/topics/21933

#5 Updated by over drive 11 months ago

Thanks for the feedback,
can you response to the thread I created?
Because i dont know i understand the hw cam support in the right way.

https://tvheadend.org/boards/13/topics/21933

Also available in: Atom PDF